HP XW4300 Workstation

• Intel Pentium 4 processor 660 supporting Hyper-Threading Technology (3.6 GHz/ 2 MB, 800 FSB, Single Core)

• 512 MB DDR-2 PC2-4300 (533 MHz) ECC (2 x 256 MB)
• 512 MB DDR-2 PC2-5300 (667 MHz) ECC (2 x 256 MB)
• 1 GB DDR-2 PC2-4300 (533 MHz) ECC (2 x 512 MB)
• 1 GB DDR-2 PC2-5300 (667 MHz) ECC (2 x 512 MB)
• 1.5 GB DDR-2 PC2-4300 (533 MHz) ECC (2 x 256 MB + 2 x 512 MB)
• 2 GB DDR-2 PC2-4300 (533 MHz) ECC (4 x 512 MB)
• 2 GB DDR-2 PC2-5300 (667 MHz) ECC (2 x 1 GB)
• 4 GB DDR-2 PC2-5300 (667 MHz) ECC (4 x 1 GB)
• 256 MB DDR-2 PC2-4300 (533 MHz) non-ECC (1 x 256 MB)
• 512 MB DDR-2 PC2-4300 (533 MHz) non-ECC (2 x 256 MB)
• 1 GB DDR-2 PC2-4300 (533 MHz) non-ECC (4 x 256 MB)

   NOTE:

Do not mix ECC and non-ECC memory. The system will not boot if ECC and non-ECC DIMMs are mixed. Only unbuffered DDR2 DIMMs are supported. All DIMMs must be either x8 or x16 width.

• Typical 733.8 btu/hr
• Maximum 2415.4 but/hr

• One processor (1 x 3.6 GHz 2 MB L2 Cache, Pentium 4 Processor with HT Technology)
• One GB memory (2 x 512 MB) Two hard drives (2 x SATA 40 GB)
• CD-ROM drive
• PCI Express Graphics Card (NVIDIA FX 1400)
• One diskette
• Monitor

• 92 mm

• 70 or 80 mm

• 92 mm

• 5^o to 35^o C (40^o to 95^o F)

• -40^o to 60^o C (-40^o to 140^o F)

• 8% to 85% (non-condensing at ambient)

• 8% to 90% (non-condensing at ambient)

• 3,000 m (10,000 ft)

• 9,100 m (30,000 ft)

• One Front fixed stereo analog Microphone-In (20-K ohm Input Impedance);
• One Front fixed stereo Headphone-Out (expects at least a 32ohm load)
• One Line-In* (12-K ohm Input Impedance)^*
• One Line-Out^* (less than 800 ohms Output Impedance, expects at least a 10-K ohm load)
• One Stereo analog Microphone-In* (20-K ohm Input Impedance)

     NOTE:

  *Rear audio port are re-taskable as Line-In, Line-Out, Microphone-In, or Headphone-Out with Optional driver, available only through download from HP support website and not supported by default. External Speakers need to be powered externally.